Table of Contents
Advertisement
Maintenance
9.3 Corrective maintenance
Procedure
1. Replace the damaged components.
2. Remove any dirt from the components. Remove any grease and the remains of sealant or
liquid threadlocker.
3. Prepare the bearing seats:
– Lightly oil the inner ring seat.
– Grease the outer ring seat with a solid lubricant such as Altemp Q NB 50.
– Press the inner bearing cover onto the shaft.
4. Warm up the rolling bearing.
5. Push the inner ring of the warmed up rolling bearing onto the shaft. Avoid any blows that
might damage the bearing.
6. Make sure that the rolling bearing is resting against the shaft shoulder or the second bearing.
7. Fill the bearing to the top with the specified lubricating grease as stamped on the lubricant
plate.
8. Warm up the grease slinger and push it onto the shaft.
9. Depending on the particular version, fix the bearing with a locking ring or shaft nut.
10.Support the rotor when installing the bearing housing or bearing end shield.
11.Use a suitable sealant when assembling.
12.Assemble the bearing shield or bearing housing together with the bearing shield.
13.Install the outer bearing cover if one is being used.
14.Install the sealing elements:
See also
Replacing rolling bearings (Page 98)
Sealing the bearings
Note the following details:
● Shaft sealing rings are used to seal machines at the rotor shaft.
– For V rings, comply with the assembly dimension.
● Use the specified bearings.
● Ensure that the bearing sealing disks are in the correct position.
● Insert the elements for bearing preloading at the correct end.
● Fixed bearings can have a locking ring or bearing cover.
● Seal the bearing cap screws with the appropriate gaskets or with grease.
● Do not interchange the position of the bearing covers (DE and NDE or inner and outer).
92
1PC134, 1PC136 crane motors SH 132 ... 315
Operating Instructions, 02/2019, A5E43212221A
Advertisement
Table of Contents
