Reset To Factory Default; Indicate Module - ABB SAM600 Series Engineering Manual

1MRK 511 433-UEN B
IEC18000672 V1 EN-US
Figure 41: PCM600: SAM600 module Simulation Mode
5.6.4

Reset to factory default

Reset to Factory Default can be launched from a SAM600 system configuration context menu,
see Figure
technical key to its default value. The physical topology is retained as it is.
IEC18000674 V1 EN-US
Figure 42: PCM600: Reset to Factory Default
5.6.5

Indicate module

Indicate Module action can be launched from the module context menu. This tool identifies
the physical hardware module in a SAM600 system. When Indicate Module option is selected,
LEDs on the corresponding hardware module flashes for 20 seconds.
SAM600 Process Bus I/O System
Engineering manual
42. This clears the configuration including sample values and set the parameters,
© Copyright 2017 ABB. All rights reserved
Section 5
SAM600 Engineering
GUID-0C3BB09C-ED84-4A59-96CF-1A94AF747B3B v1
GUID-E62C6335-5B02-41A7-96CA-4E9498E22079 v1
39