Analog Output Default Jumpers; Analog Output Mode Jumpers - ABB Symphony Harmony Series Instruction

Setup and Physical Installation
Analog Output Default Jumpers (J7, J8, J12, J14, J10, J16)
The analog output default jumpers determine the I/O module
analog output default values. These are the values or levels for
the analog outputs during system startup (power up) or bus
fault error (time-out).
Select either a zero percent or 100 percent power up output.
Selecting zero percent will output 4 milliamperes or 1 VDC;
selecting 100 percent will output 20 milliamperes or 5 VDC.
If the bus fault timer expires (times out), the digital outputs
de-energize and the analog outputs change to the default value
selected. A time-out occurs when the I/O module does not
receive a clock signal from the controller. The time-out options
are to hold or go to power up state. The outputs will stay at
their current values during a time-out if the hold option is
selected; they will change to the power up values (zero or 100
percent) if the go to power up state is selected.
Refer to Figure
for jumper settings.
Table 3-2. Analog Output Default Jumpers
Analog
Output
Jumper
1 J8
2 J14
Analog Output Mode Jumpers (J9, J11, J13, J15)
The analog output mode jumpers select the mode of each ana-
log output. The mode can be set to current (4 to 20 milliam-
peres) or voltage (1 to 5 VDC). Refer to Figure
of jumpers and Table
Table 3-3. Analog Output Mode Jumpers
3 - 4
3-1 for location of the jumpers and Table
NOTE: Jumpers J10 and J16 are not required.
Time-Out Option
Go To Power-Up
2-3
2-3
3-3
Analog Output Jumper
1 J9, J11
2 J13, J15
Power-Up State
Hold Jumper
1-2 J7
1-2 J12
for jumper settings.
Current Mode
2-3
2-3
3-2
0% 100%
2-3 1-2
2-3 1-2
3-1 for location
Voltage Mode
1-2
1-2
WBPEEUI240769B0