Downloading And Uploading Configurations - ABB LST100 Operating Instructions Manual

5 Configuration

5.3 Downloading and uploading configurations

To download a device configuration:
1. Log on to the LST100 using the following logon information:
User name: LSTCONFIG
Password: 5159
IMPORTANT (NOTE)
The password 5159 is the default user password.
If the user password has been customized,
use the updated password.
After successfully logging on, the LST100 responds
with the current device configuration in the following format:
---Start of configuration file---
{
>1=1\r
>2=2\r
>3=3\r
>4=4\r
>5=5\r
...
}
---End of configuration file---
2. Select the text shown in red above.
3. Copy the text and paste it into a text editor (for example,
Notepad).
4. Save the file to a known location as a configuration
backup or for upload to another device.
18 OI/LST100-EN | LST100 – Ultrasonic level transmitter
To upload a device configuration:
1. Log on to the LST100 using the following logon information:
User name: LSTCONFIG
Password: 5159
IMPORTANT (NOTE)
The password 5159 is the default user password.
If the user password has been customized,
use the updated password.
2. Select Transfer in the HyperTerminal toolbar and select
Send Text File... to open the file explorer window.
3. In the file explorer window, browse to the configuration
file saved at step 4 in the download instructions. Select
the file and click Open. HyperTerminal sends the
configuration to the LST100.
4. The LST100 responds with a status message indicating
upload success or failure in the following format:
---Start of response message---
There is not nv error now.
<0>1=1\r
<0>2=2\r
<0>3=3\r
<0>4=4\r
<0>5=5\r
...
---End of response message---
5. Enter Q (or q) to exit the upload interface.