Graco EcoQuip 300 Operation, Repair, And Parts page 5

EQUIPMENT EQUIPMENT EQUIPMENT MISUSE
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See
• Do not use this equipment without hose restraints and coupler pins installed on all air and
blast hose couplings.
• Do not blast unstable objects. The high amount of fluid flow from the nozzle can potentially
move heavy objects.
• Do not exceed load rating of lift eyes.
• Do not operate equipment on or stand on an unstable support. Keep effective footing and
balance at all times.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the
not in use.
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
BURN HAZARD HAZARD
BURN BURN HAZARD
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid
severe burns:
• Do not touch hot fluid or equipment.
FIRE AND AND EXPLOSION
FIRE FIRE AND
Flammable fumes, such as solvent, in work area can ignite or explode. To help prevent fire
and explosion:
• Use equipment only in well ventilated area.
• Abrasive material exiting blast nozzle can generate sparks. When flammable liquids are used
near the blast nozzle or for flushing or cleaning, keep the blast nozzle at least 20 feet (6
meters) away from explosive vapors.
• Keep work area free of debris, including solvent, rags and gasoline.
• Keep a working fire extinguisher in the work area.
334667G
WARNING WARNING WARNING
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Specifications,
Technical Technical
EXPLOSION HAZARD HAZARD
EXPLOSION HAZARD
Specifications, page page 49 49
Specifications, page 49
Pressure Pressure Relief Pressure Relief Procedure, Relief Procedure, page Procedure,
in all equipment manuals.
page 10 page 10 10 when equipment is
Warnings
5