Lifting Inner End Of Spring - Piper Lance II Service Manual

LANCE II SERVICE MANUAL
810
Figure 8-26. Lifting Inner End of Spring
h. Insert a spare rotating magnet, with woodruff key in taper, into cam assembly. Turn
magnet slightly in direction of coupling rotation (to wind spring). Lift magnet with cam
only enough to clear projections on the body. Wind spring one-half turn and re-engage the
cam assembly into the body.
i. Tension of the spring assembly in the assembled coupling when wound to point of
impulse tripping must not be less than 9 or more than 15 inch-pounds.
8-35. HARNESS ASSEMBLY.
8-36. INSPECTION OF HARNESS
a. Inspect cover for cracks or other damage. Inspect lead assemblies for abrasions,
mutilated braid or other physical damage.
b. Inspect grommets for tears and eyelets for spark erosion.
c. Disconnect harness coupling nuts from the spark plugs and extract the lead
terminations. Inspect contact springs and compression springs for any damage or distortion.
Inspect sleeves for cracks or carbon tracking.
d. Inspect coupling nuts and elbow assemblies for damaged threads or other defects.
NOTE
Replace any damaged components per instructions given in
Paragraph 8-37.
Issued: 1/3/78
POWER PLANT
2B16