Table of Contents
Advertisement
2.14 Reassemble the thermostat parts, water outlet pipe seat and water outlet connection pipe
(1) Install the thermostat parts on the water outlet flange face of 1
st
cylinder cover and fix it with
two M6X40 bolts.
nd
(2) Install the water outlet pipe seat on the water outlet flange face of 2
cylinder cover and fix
it with two M6X20 bolts.
(3) Check the hoop of water outlet connection pipe which connects the thermostat parts and
water outlet pipe seat.
2.15 Reassemble the water outlet pipe weldment
(1) Fix the water outlet pipe weldment with one M8X10 bolt.
(2) Connect the thermostat and water outlet pipe weldment with a hose and lock it with hoop 40.
2.16 Reassemble the inlet pressurizer tank parts
(1) Install the 0-seal ring 40X2.65 on the inlet flange groove of pressurizer tank.
(2) Install the flange face of inlet pressurizer tank on the cylinder cover inlet port and fix it with
two M6X18 bolts.
2.17 Reassemble the air conduct cover parts
(1) Install the air conduct cover parts on the flywheel end and fix it with three M10X20 bolts.
(2) Fix the air conduct cover seat and engine seat with four M6X18 bolts.
2.18 Reassemble the fan seat, fan gasket and fan impeller
(1) Install the fan seat on the flywheel end and fix it with three M6X16 bolts.
(2) Fix the fan gasket and fan impeller on the fan seat with four M6X20 bolts.
2.19 Reassemble the heat abstraction tank and overflow tank parts
(1) Install the heat abstraction tank and fix it with four M8X110 bolts and nuts.
(2) Install the overflow tank.
(3) Connect the water inlet port and outlet pipe weldment with a water tank connection hose and
lock it with hoop 40.
(4) Connect the water outlet port and water pump inlet port with a water pump inlet hose and
lock it with hoop 40.
2.20 Reassemble the air filter assembly
(1) Fix the installation seat of air filter with two M8 nuts and washers.
(2) Connect the connection hose of pressurizer tank with the inlet port of air filter, and lock it with
hoop.
2.21 Reassemble the muffler weldment
(1) Install the muffler weldment on the cylinder cover and fix it with four M8 nuts.
Hide quick links:
Advertisement
Table of Contents
