Procedure Of Periodic Check; First 50H Operation Check; Check Per 50H Operation; Check Battery - Kipor KM2V80 Manual

Check and adjust fuel injection
Fuel
pressure
injector
Timing check and adjust of fuel
and fuel
injection
injection
Maintenance of fuel injector
pump
and fuel injection pump
the lube oil and oil filter element. Oil draining is much easier and quicker when the engine is hot.
Notice: Prevent be scalded when draining out the hot oil, and don't let the hot oil splash on you.
2.1.1 Drain out lube oil: Prepare an oil basin to store oil before draining, loosen the drain screw
with a spanner, and then begin to drain oil. Make sure you have tightened the drain screw after
draining to prevent be dropped out.
Danger: Indicate that severe damage will result if you haven't tightened the drain screw.
2.1.2 Replace oil filter element: Revolve down the oil filter element with a filter element spanner
in anticlockwise direction, clean the oil filter seat, smear a thin lube oil on the filter element
sealing gasket before replacing, revolve hard with hand in clockwise direction, then revolve 3/4
circle with filter element spanner.(Tighten torque valve20-23N.m)
2.1.3 Refill fuel, about 6.9L.
Run the engine 5 minutes to preheat the engine, and check for oil leakage. Recheck fuel after
stop running 10 minutes, and refill to the upper limit line.
After the initial maintenance, replace fuel and oil filter element regularly per 250h interval.

2.2 Check per 50h operation

2.2.1 Drain out fuel tank: Prepare an oil basin; revolve down the drain screw, drain out water and
other foreign matter in the fuel tank; install drain screw and tighten up, check for oil leakage.
2.2.2 Check battery: Disconnect battery negative electrode earth wire when checking the electric
appliance system, or fire will result by short circuit; Make sure to be well-ventilated, or hydrogen
caused during charging will burn; Check battery electrolyte and refill to the upper limit location if
it is gong to reach the lower one, otherwise life of battery will be shorten, or even explosion will
be caused. You should always check and refill distilled water since electrolyte lever drops down
quickly in summer. Please recharge the battery if rotation speed of crankshaft is slower than
normal and starting is failure. If you still can't start the engine after recharging, replace the battery.
2.2.3 Clean air filter: Air filter element will easily be polluted by dust, oil mist or steam, which will
result in increase of intake resistance, decrease of intake volume, and black smoke of engine,
so you should always check and clean the oil filter element, or even replace it; Cleaning should
be more frequent if operating at
○：check ：replace

2. Procedure of periodic check

2.1 First 50h operation check

At the beginning time of operation, the inner parts wear
mutually and the lube oil is polluted soon, so please replace
○
●：Contact with Kipor
agent
○
●