Disassemble The Cylinder Cover Parts; Disassemble High Pressure Oil Pipe Parts And Fuel Injector Assembly - Kipor KM2V80 Manual

1.9 Disassemble the rear support plate parts of starting motor and starting motor parts
(1) Loosen the M10X20 bolt which fixes the rear support plate of starting motor on the engine
side cover.
(2) Loosen the two M10X30 bolts which fix the starting motor parts.
(3) Remove the starting motor parts and rear support plate of starting motor.
Refer to picture 19
picture 19

1.10 Disassemble the cylinder cover parts

(1) Loosen the four M6X25 bolts which fix the cylinder cover.
(2) Remove the cylinder cover parts
Refer to picture 20
picture 20
1.11 Disassemble the high pressure oil pipe parts and fuel injector assembly
(1) Loosen the tie of high pressure oil pipe which connects the fuel injection pump and fuel
injector. Remove the high pressure oil pipe parts.
st
(2) Loosen the fuel injector of the 1 cylinder, take out the fuel injector, two washer and heat
insulation sleeve from the cylinder cover.
(3) Disassemble the fuel injector of 2 nd cylinder in the same way.
Refer to picture 21