Table of Contents
Advertisement
5 COUNTERS
This Parameter Family collects cycle counters and water consumption counters.
For water consumption counters a flow meter must be installed. See
section (8 OTHER PARAMETERS).
5.1 Counters
Sym.
Parameter Description
Cycles performed counter.
is obtained by joining the two numbers.
→ →
Ex.
Cycle counter (resettable).
This counter is similar to
parameter below).
Water Consumption (only for dishwashers with incorporated continuous
water softener).
Counts m
Water Consumption (only for dishwashers with incorporated continu-
ous water softener).
Counts litres of water consumption.
The total consumption is given by adding
Water Consumption: resettable counter. [present up to software version
3.12]
Counts the litres of water and is resettable by user (see
ter below).
Reset resettable counters:
To reset put 1 this parameter, switch off and then on again:
Store thousand of cycles after that
play.
Ex. If this parameter is settled to 20,
Drain/Cleaning cycles performed.
Similar to
Numbers of cycles that can be made after a regeneration cycle (only for
dishwashers with non-continuous water softener) [See paragraph 9.1
RESIN REGENERATION CYCLE.].
Regeneration cycle counter (only for water softener dishwasher)
[See paragraph 9.4 DISHWASHER WITH INCORPORATED CONTIN-
UOUS WATER SOFTENER].
cycles, i.e. those carried out with salt in the special container (only for
dishwashers with incorporated continuous water softener)
Counter of regeneration cycles done without salt in the special con-
tainer. (only for dishwashers with incorporated continuous water sof-
tener) [See paragraph 9.4 DISHWASHER WITH INCORPORATED
CONTINUOUS WATER SOFTENER].
DOC. NO. 5956.65J.00
EFS - Dishwashing Systems Platform
Electrolux Professional
symbol and two numbers blink consecutively. The cycle number
means 10042 cycles executed.
but is resettable by user (see
3
of water consumption.
and
will show zero. Note that
message (see next parameter,
reach 20.000 cycles.
but counts Cleaning Cycles.
3
[m
[l] values.
] and
parame-
is used to count cycles for
).
message appears on dis-
message appears when
only counts efficient regeneration
(calibration parameter) into
Unit
Min
Max
-
-
3
[m
]
[l]
[l]
and
-
-
-
-
-
-
Factory
Default
20
P. 9 / 174
Hide quick links:
Advertisement
Table of Contents
