Table of Contents
Advertisement
OHTAROW - OHTAROW60
1. Switch OFF and then switch ON the machine.
2.
3. Switch OFF and then switch ON the machine.
4. Modify Factory parameters:
5. Modify the cycle parameters:
DOC. NO. 5956.65J.00
EFS - Dishwashing Systems Platform
Electrolux Professional
Enter into CFG parameter family and set the following parameters:
Hood Type and undercounter.
Atmospheric boiler.
Manual Hood.
Default values for Hood Type models.
Disabled (for this appliance SOFT START is NOT possible).
Boiler heaters and tank heater work simultaneously.
Enable filling tank by means of rinsing cycles.
Detergent level switches not enabled.
Select user interface hood type/ undercounter model.
Regeneration cycle disabled (only for dishwashers with non-continuous water softener).
Alarms enabled.
Boiler electronic level sensor.
Resin regeneration cycle forcing.
Rinse water max. hardness.
Boiler heating control.
Enter into FAC parameter family and set the following parameters.
Boiler Temperature Threshold.
Disable boiler high Temperature alarm (
Boiler Temperature Adjust.
Boiler standby function enabled.
Booster Function.
During stand-by boiler is kept at lower temperature than Temperature Threshold.
Tank Temperature: Threshold.
Disable tank high Temperature alarm (
Cycle 1 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Long Wash Phase inTermal Label mode [min].
Short Wash Phase inTermal Label mode [s].
Cycle 2 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Long Wash Phase inTermal Label mode [min].
Short Wash Phase inTermal Label mode [s].
PROG 127
).
).
P. 82 / 174
Hide quick links:
Advertisement
Table of Contents
