Electrolux EPPWELGM5 Service Manual page 121

NUC1DDRUKP



6. Switch OFF and then switch ON the machine.

7. Switch OFF and then switch ON the machine.
WARNING:
To set the board parameters , carefully follow the order given in this programming file, from point 1 to
point 7.
WARNING:
When modifying parameter , all the parameters (except those belonging to the  family)
assume the default values according to the tables in section 11 DEFAULT VALUES. The parameters of
the  family are not modified.
WARNING:
To limit maximum absorption at 13A (the appliance is single phase with plug 13A UK), the following
must not work at the same time:
- the wash pump and tank heating element,
- the booster heating element and tank heating element.
DOC. NO. 5956.65J.00
EFS - Dishwashing Systems Platform
Electrolux Professional
Drain parameters family.
 
Initial Drain Phase Duration [s].
 
Final Drain Phase Duration [s].
 
Drain and cleaning mode.
 
Wash tank water change frequency control disabled.
Set other parameters.
 
Initial Pause [s] (for ALL cycles).
 
Delay for the 2
 
Drain Phase Duration at the end of washing phase [s].
 
Duration of pause after the rinse cycle [s] (for ALL cycles).
 
Degrees Celsius display.
 
During the rinse stage, the display shows the boiler temperature.
Enter into HCP parameter family and set the following parameters.
 
Machine arranged for remote connection to PC.
Enter into GEn parameter family.
 
Initial Detergent Dosage.
 
Initial Rinse Aid Dosage.
 
Detergent dispenser works when LOAD SOLENOID VALVE in activated.
 
Rinse Aid dispenser works when LOAD SOLENOID VALVE in activated.
nd
wash pump [s].
PROG 146
P. 121 / 174