Playing Mds Playing An Md - Sony MDS-PC3 M-crew Operating Instructions Manual

Dat / minidisc decks: mini size md recorder
Hide thumbs Also See for MDS-PC3 M-crew:
Table of Contents

Advertisement

Playing MDs
Playing an MD
The operations for normal play are explained
below.
Z
Z
N
N
X
./>
.
>
m
M
1
Turn on the amplifier and select MD on
the amplifier.
2
Press ?/1 to turn on the deck.
The switch indicator on the deck turns off.
3
Insert an MD (page 4).
4
If necessary, press ./>
repeatedly (or turn ./> on the
deck) to locate the track you want to
start playing from.
If you want to play from the first track, go to
step 5.
5
Press N (or NX on the deck).
The deck starts to play.
6
Adjust the volume on the amplifier.
?/1
?/1
X
x
x
z
+
LEVEL +/–
g
Operations you may want to do
during play
To
Press
x (or x/Z on the deck)
Stop play
Pause play
X (or NX on the deck)
N or X (or NX on the
Resume play after
pausing
deck)
> repeatedly (or turn
Locate a succeeding
./> clockwise on the
track
deck)
. repeatedly (or turn
Locate the beginning
./> counterclockwise
of the current track
or a preceding track
on the deck)
EJECT Z (or x/Z on the
Eject the MD
deck) after stopping play
z
When you play an MD recorded in
LP2 or LP4 stereo mode
"LP2" or "LP4" appears in the display when you
press N (or NX on the deck).
z
Using headphones
Connect headphones to the PHONES jack on the rear
of the deck. You can adjust the volume of the
headphones with LEVEL +/–. The output level of the
ANALOG OUT jacks changes with the volume of the
headphones, from –
dB to 0 dB. This output is
factory set at – 14.0 dB. When recording from the
deck to another audio component, be sure to set the
output level to 0 dB ("ATT" turns off in the display).
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cav-mn10

Table of Contents