Playing An Md Right Away - Sony Walkman MZ-R4ST Operating Instructions Manual

1 Attach the recorder to the station.
1 Place the right side of the
recorder.
2 Push down until it clicks.
Make sure to attach the
recorder in the right way. Pushing
with force may cause a
malfunction.
2 Insert a recordable MD.
1 Slide the 開く(open) switch and
open the lid.
2 Insert a recordable MD with
the label side facing up. and
press the lid down to close.
3 Select the input source.
Set 入力切換 (input select)
the connected input.
Select "デジタル（光）" to record
signals from デジタル（光）入力
(OPTICAL IN).
Select "アナログ" to record signals
from 入力(LINE IN).
4 Select recording start point.
If you want to add a recording to the
end of the previous recording, press エ
ンドサーチ(end search).
(If you want to start recording from the
beginning, skip this step).
Start recording.
5
1 Slide the 録音(record) switch
to the right while pressing its
button.
"REC" lights up and recording starts .
2 Play the sound source.
To stop recording, press p.
Do not move or jog the recorder or disconnect
the power source while the "TOC EDIT"
indication is flashing in the display.
To
Press
Pause
P*
Press P again to
resume recording.
(, + or = to
Record over
find the start point of
partway through
recording and press
the previous
p to stop. Then slide
recording
the 録音 (record)
switch.
Remove the MD
p ,then slide the 開く
(open) switch and
open the lid.**
Turn power off
電源(Power)
* A new track mark is added at the point
where you pressed P, and the recording
will be marked with the new track number
when you resume recording.
** Once you open the lid, the point to start
recording will change to the beginning of the
first track. When recording on a recorded
MD, check the point to start recording on the
display.
If the recording does not start
Make sure the MD is not record-protected.
If the tab at the side of the MD is open,
slide it back so the tab is visible.
zMD playing
switch to

Playing an MD right away!

See the illustrations in the Japanese text
(pages 12 to 13). The following explains
how to play MDs on the recorder while
detached from the station.
Before playing, insert the dry batteries or
rechargeable battery into the recorder (see
page 30).
1 Detach the recorder from the station.
1 Slide the 本体取りはずし
2 Connect the remote controller-
2 Insert an MD.
1 Slide the 開く(open) switch
2 Insert an MD with the label
3 Start playing.
1 Press(.
2 Press the 音量(volume) -/+
To stop play, press p.
A long beep sounds in the headphones.
(detach recorder) switch.
equipped headphones
(supplied) to the 2/リモコン
jack.
and open the lid.
side facing up, and
press the lid down to close.
A short beep sounds in the
headphones.
buttons to adjust the volume.
You can check the volume in
the display.
55