Editing Recorded Mds - Sony MDS-PC3 M-crew Operating Instructions Manual

Editing Recorded MDs

./>
m/M
MENU/NO
Brief descriptions of buttons
used to edit MDs
The buttons below are used to erase, divide, move,
or combine tracks on the MD.
Note
The operation of these buttons is different when
naming a track or MD. For details, see "Naming
Tracks or MDs" on page 35.
MENU/NO button: Press to edit tracks. While
editing, press to cancel editing.
./> buttons: Press to select an editing
operation or track number. You can also use these
buttons to specify points in a track for erasure or
track division. You can also perform the same
operation by turning ./> on the deck.
YES button: Press to enter a selection. You can
also perform the same operation by pressing
./> on the deck.
m/M buttons: Press to specify the unit
(minute, second, or frame) by which the MD is
advanced when you press ./> repeatedly.
You can also use these buttons to locate the end
point of the portion to be erased.
For further details on the function of each button,
see the sections on editing operations.
28
?/1
Z
N X x
z
. >
m M
+
YES
–
g
About indication which
appears while editing
When "Protected" and "C11"
alternate in the display
The record-protect slot is open. To edit the MD,
slide the tab to close the slot. For details, see "To
prevent accidental erasure of the recorded
material" on page 13.
About indications which
appear after editing
When "TOC" lights up in the
display
Editing has finished but the TOC (Table of
Contents) on the MD has not been updated to
reflect the editing results. The editing will be lost
if you disconnect the AC power adaptor while the
indication is on. The TOC will be updated only
when you eject the MD or turn off the MD deck.
When "TOC Writing" flashes in
the display
The deck is updating the TOC. Do not disconnect
the AC power adaptor or move the deck while the
indication flashes.