General; Playing An Md - Sony MZ-E710 Service Manual

MZ-E710
The Player
1 2
qs
qa
q;
9
1 x button
2 .• u*• > button
3 "3-color info-LED"
4 GROUP button
5 Hand strap hole
Use the hole to attach your strap
6 i (headphones/earphones) jack
7 OPEN switch
8 Terminals for charging stand (at the
bottom)
9 Terminals for dry battery case (at the
bottom)
q; HOLD (Locking the control) switch
qa VOLUME +, – buttons
qs Battery compartment
* u has a tactile dot.
The display window of the remote
control
1 2 3
7
1 Disc indication
2 Track number display
3 Character information display
4 Group play indication
5 Play mode indication
6 Virtual-Surround/6-band equalizer
indications
7 Battery level indication
8 Bookmark indication
9 Alarm indication
The battery charging stand
A
B
1 DC IN (3V jack) (at the bottom)
2 Terminals for charging
The headphones/earphones with a
remote control
A
B
C
D
5
F
1 Headphones/earphones
2 Stereo mini plug
3 Control VOL +, –
Turn to adjust the volume .
4 x (stop) button
5 Jog lever (.• u/ENT• >) button
6 (Group) +, – button
7 Clip
8 HOLD switch
9 Display window
q; DISPLAY button
qa P MODE /
(play mode/repeat) button
qs SOUND button
4
SECTION 2

GENERAL

3
D
E
6
7
8
4 5 6
8 9
7
8
9
q;
qa
qs

Playing an MD

1
Insert an MD .
1 Slide OPEN to open the lid.
1
Insert an MD with the label side facing up, pushing the
MD to the direction of the arrow in the illustration.
2
Play an MD .
. u >
x
VOLUME +, –
(at the bottom)
1 Press the jog lever ( u) on the remote control. (Press u on the playe
A short beep sounds in the headphones/earphones. The LED lights up.
2 Turn the control towards VOL + or – on the remote control to adjust the
volume. (Press VOLUME + or – on the player. )
The volume indicator appears in the display, allowing you to check the
volume level.
To stop play, press x .
A long beep sounds in the headphones/earphones.
Playback starts from the point you last stopped playing. To start playback from the
beginning of the disc, press and hold the jog lever (u) for 2 seconds or more on the
remote control (Press and hold u for 2 seconds or more on the player).
To Do this (Beeps in the headphones/earphones)
Pause Press the jog lever (u) on the remote control (continuous short
beeps). (Press u on the player.)
Press the jog lever (u on the player) again to resume play.
Cue to the current track Slide the jog lever towards . on the remote control
or the previous track (three short beeps). (Press . on the player. )
Cue to the next track Slide the jog lever towards > on the remote control (two short
beeps). (Press > on the player.)
Slide and hold the jog lever towards . or > on the remote
Go backwards or
control. (Press and hold . or > on the player.)
forward while playing
Searching for a specific While the player is paused, slide and hold the jog lever towards
position while viewing . or > on the remote control.
a elapsed time
(Time search)
Searching for a specific While the player is stopped, slide and hold the jog lever towards
track while viewing . or > on the remote control.
track numbers or
track names
(Index search)
Cue to the beginning of Press + or – button.
every 10th track
(only during playback of
the disc with no group
settings 1) )
Remove the MD Press x, and then slide OPEN .
1)
For more details, see "Using the group function."
2) Once you open the lid, the point to start play will change to the beginning of the first track (except
when the disc information has been stored in the personal disc memory).
About the "3-color info-LED"
The LED indicates the current operating mode, charging status, and battery condition. For
details about the charging status, see "Getting started." For details about the battery condition,
see "When to replace or recharge the battery" on the back page.
LED color Operating status
Red
Playing a disc with no group settings
Green
Playing a disc with group settings
Orange
Cueing to the another group (Group Skip)
This section is extracted from
instruction manual.
2 Insert an MD. 3 Close the lid.
3
2
VOL–
VOL+
x
Jog lever
(.• u/ENT•>)
"3-color info-LED"
2)