Setting Play Start Position After Play Is Stopped (Resume Play); Returning To The Specified Point (Locate Play) - Sony MDS-E10 Operating Instructions Manual

Setting Play Start Position
After Play Is Stopped
(Resume Play)
After play is stopped by pressing STOP, you can set play
start position when play starts.
1
While the recorder is stopped, press MENU/NO
twice.
"Setup Menu" appears in the display.
2
Turn AMS (or press ./> repeatedly) to select
"Resume Mode," then press AMS or YES.
3
Turn AMS (or press ./> repeatedly) to select
from the following three edit modes:
Resume Off: No resume play is performed.
Resume Play: Play starts from the position of previous
stop.
Resume Next: Play starts from the beginning of the
next track of the previously stopped
track.
Press AMS or YES.
4
Press MENU/NO.
Note
Resume Play becomes OFF forcibly and does not work
during Shuffle Play or Multi-access Play.
If you use Resume Play again, reset by the above
procedure.
36
MENU / NO YES
AMS
Returning to the Specified
Point (Locate Play)
You can repeatedly locate the desired setting point.
To mark the desired point (MARK)
The following two ways can be used to determine the
point.
1
Press AMS (MARK) during play.
The play time when AMS is pressed is determined the
specified point. "MARK" lights up at the display
window.
- M A R K
2 4 m 0 9 s
T r
2
Specify numeric directly for the track number and
play time to set the point.
1 While the recorder is stopped, press MENU/NO
twice.
"Setup Menu" appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
"Direct Mark", then press AMS or YES.
3 Turn AMS to display the track number to be
located , then turn AMS.
2 T r
4 Similarly with step 3, set minutes, seconds, and
frames in order to locate a point.
"Complete!" appears and "Mark" lights up at the
display window, then normal display is returned.
You can slide a position for each frame* (f) (1 frame =
1/86 seconds).
* Monaural or LP2 stereo tracks move two frames at
a time, LP4 stereo tracks move four frames at a
time.
To set quickly, press m/M repeatedly in step 4.
Change units advanced when AMS is turned (or
m/M is pressed) to frames, seconds, or minutes.
MENU / NO YES LOCATE
AMS
(MARK)
-
0 m 0 0 s
0 0 f