IBM DS8880 Series Introduction And Planning Manual page 54

42
DS8880 Introduction and Planning Guide
Table 21. Feature codes for hardware features (continued)
Feature
code Feature
1088 Three-phase high voltage (five-wire
3P+N+G), 380-415V, 40 A, no customer
connector provided
1089 Three-phase low voltage (four-wire
3P+G), 200-240V, 60 A, IEC 60309
4-pin customer connector
1101 5 ft. ladder
1102 3 ft. platform ladder
1103 Rolling step stool
1141 Primary management console
1151 Secondary management console
1241 Drive enclosure pair total
1242 Standard drive enclosure pair
1244 Standard drive enclosure pair
1245 Standard drive enclosure pair
1246 Drive cable group A
1247 Drive cable group B
1248 Drive cable group C
1249 Drive cable group D
1251 Drive cable group E
1252 Extended drive cable group C
Description
Inline Connector: not applicable
Receptacle: not applicable
HBL460C9W, Pin and Sleeve
Connector, IEC 60309, 3P4W
HBL460R9W, AC Receptacle, IEC
60309, 3P4W
For models 984 and 84E, 985 and
85E, 986 and 86E, 988 and 88E
For models 984 and 84E, 985 and
85E, 986 and 86E, 988 and 88E
For models 984, 985, 986, and 988
A primary management consoles is
required to be installed in the model
984, 985, 986, and 988
Redundant management console for
high availability
For model 984, 985, 986, and 988, this
feature is optional
Admin feature totaling all disk
enclosure pairs installed in the model
For 2.5-inch disk drives
For 3.5-inch disk drives
For 400 GB flash drives
Connects the disk drives to the
device adapters within the same base
model 985 or 986
Connects the disk drives to the
device adapters in the first expansion
model 85E or 86E
Connects the disk drives from a
second expansion model 85E or 86E
to the base model 985 or 986 and first
expansion model 85E or 86E
Connects the disk drives from a third
expansion model 85E or 86E to a
second expansion model 85E or 86E
Connects the disk drives from a
fourth expansion model 85E or 86E
to a third expansion model 85E or
86E
For model 85E or 86E, 20 meter cable
to connect disk drives from a third
expansion model 85E or 86E to a
second expansion model 85E or 86E