IBM DS8880 Series Introduction And Planning Manual page 227

CAUTION:
The system contains circuit cards, assemblies, or both that contain lead solder. To avoid
the release of lead (Pb) into the environment, do not burn. Discard the circuit card as instructed by
local regulations. (C014)
CAUTION:
This product is equipped with a 3-wire (two conductors and ground) power cable and
plug. Use this power cable with a properly grounded electrical outlet to avoid electrical shock.
(C018)
CAUTION:
This product might be equipped with a hard-wired power cable. Ensure that a
licensed electrician performs the installation per the national electrical code. (C022)
CAUTION:
Ensure the building power circuit breakers are turned off BEFORE you connect the
power cord or cords to the building power. (C023)
CAUTION:
To avoid personal injury, disconnect the hot-swap, air-moving device cables before
removing the fan from the device. (C024)
CAUTION:
This assembly contains mechanical moving parts. Use care when servicing his
assembly. (C025)
CAUTION:
This product might contain one or more of the following devices:
CD-ROM drive, DVD-ROM drive, DVD-RAM drive or laser module, which are Class 1 laser
products. Note the following information:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of the controls or adjustments or performance of the procedures other than those specified
herein might result in hazardous radiation exposure. (C026)
CAUTION:
Data processing environments can contain equipment transmitting on system
links with laser modules that operate at greater than Class 1 power levels. For
this reason, never look into the end of an optical fiber cable or open receptacle.
Although shining light into one end and looking into the other end of a
disconnected optical fiber to verify the continuity of optic fibers may not injure
the eye, this procedure is potentially dangerous. Therefore, verifying the
continuity of optical fibers by shining light into one end and looking at the
other end is not recommended. To verify continuity of a fiber optic cable, use an
optical light source and power meter. (C027)
CAUTION:
Servicing of this product or unit is to be performed by trained service personnel only.
(C032)
CAUTION:
or
The weight of this part or unit is between 16 and 30 kg (35 and 66 lb). It takes two persons to safely
lift this part or unit. (C040)
CAUTION:
Refer to instruction manual. (C041)
CAUTION:
Activate locks or brakes, or apply chocks as directed. Parts may shift or fall
and cause personal injury or mechanical damage if these safeguards are not used. (C042)
or
t
215
Notices