Before You Start; Safety Instructions - SPALDING NBA Arena Portable System Manual

SAFeTy INSTRucTIoNS

FAIluRe To FolloW THeSe SAFeTy INSTRucTIoNS MAy ReSulT IN SeRIouS INjuRy oR
Owner must ensure that all players know and follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions
carefully. check entire box and inside all packing material for parts and/or additional instruction
material. Before beginning assembly, read the instructions and identify parts using the hardware
identifier and parts list in this document. proper and complete assembly, use, and supervision are
essential for proper operation and to reduce the risk of accident or injury. A high probability of
serious injury exists if this system is not installed, maintained, and operated properly.
• If using a ladder during assembly, use extreme caution.
• Two (2) capable adults are recommended for this operation.
• check base regularly for leakage. Slow leaks could cause system to tip over unexpectedly.
• Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to
separate during play and/or transport of the system.
• climate, corrosion, or misuse could result in system failure.
• Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NoT excessive competitive play.
• Read and understand the warning label affixed to pole.
• The life of your basketball pole depends on many conditions. The climate, placement of the pole,
location of the pole, exposure to corrosives such as pesticides, herbicides, or salts are all
important.
• If technical assistance is required, contact customer Service.
• Adult supervision is recommended when adjusting height.
Most injuries are caused by misuse and/or not following instructions. Use caution when using this system.
To ensure optimal playability of backboard system, a close tolerance
fit between the elevator components and hardware is required. Test-fit
large bolts into large holes of elevator tubes, backboard brackets, and
triangle plates. Carefully rock them in a circular motion to ream out
pRopeRTy DAMAGe AND WIll voID WARRANTy.
BeFoRe you START!
any excess paint from holes if necessary.
Not all items pictured are included with every model.
3