Installation; Location Preparation; Wheels And Casters; Connect The Gas Supply - Primo Water G420C Installation Instructions And Owner's Manual

Table of Contents

Advertisement

LOCATION PREPARATION

Prepare a fl at, level surface capable of supporting the
weight of the stand-alone grill and convenient to the gas
supply if connecting to a gas line.

WHEELS AND CASTERS

To lock the casters press down on the lever with the word
"ON" stamped on it until it stops and the caster will not roll.
To unlock, pull up on the lever.
unlocked position

CONNECT THE GAS SUPPLY

For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE
GAS CYLINDERS.
For household propane or natural gas units:
1. Turn OFF the gas supply at the source. The quick
disconnect hose is pre-installed on the valve manifold
at the manufacturer. Run the hose through the hole
in the bottom rear of the stand-alone unit, to the gas
supply.
2. A shut-off valve is required within 6 feet of the unit.
3. Connect the quick connect hose to the shut-off valve
OR gas supply using a pipe joint compound resistant to
all gasses (see Below). Tighten securely.
Quick Connect Hose
(coming from unit)
Shut-Off Valve
(*required, not included, must be
installed within 6 feet of the unit)
4. Turn all burner valves to the OFF position. Turn the gas
supply on. Then carefully check all gas connections
for leaks with a brush and soapy water before lighting.
NEVER USE A MATCH OR OPEN FLAME TO TEST
FOR LEAKS.
PCG.rev04282017- 10:53

INSTALLATION

locked position
Quick Connector
(can be connected directly to gas
supply stub if shut-off valve is
installed in-line)
Gas Supply
INSTALL THE FLAVOR GRIDS
Place the fl avor grids directly onto the studs as shown
below. The fl avor grids allow heat from the burners to be
evenly distributed throughout the cooking area. See Below.
INSTALL THE COOKING GRIDS
Place each cooking grid onto the left and right grid rests of
the grill. See Below.
INSTALL THE DRIP TRAY
You may line the drip tray with aluminum foil at this time.
Fully insert the drip tray into the bottom front of the control
panel. See Below.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

G420h

Table of Contents