Table of Contents
Advertisement
4.9. 140 mm spindle disk set
Allows machining pipes from inside diameters of 105 mm (4.13'') to outside diameters
of 140 mm (5.51'').
Included equipment consists of the following elements.
Install the spindle disk after previously removing the existing spindle disk (Fig. 7, Fig. 8).
Then, use the following table to select jaw blocks of the set suitable to the inside
diameter of the pipe to be machined, and use the 3 mm hex wrench to tighten them
to the expanding mandrel (1, Fig. 2). Install the tool bits in the sockets and tighten the
screws (3, Fig. 2) with the 4 mm hex wrench.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
Part number:
ZST-0472-15-00-00-0
140 mm spindle disk
Jaw blocks (number 7, 8, 9)
Pipe inside diameter
with 140 mm spindle disk set
[mm]
104.4–116.6
4.11–4.59
113.6–125.8
4.47–4.95
122.8–133
4.83–5.24
This document is protected by copyrights.
23
1 unit
3 sets
Jaw block
number
[inch]
7
8
9
PRO 5 PB/PBE/PBC
Advertisement
Table of Contents
