Table of Contents
Advertisement
3.9. Replacing the spindle disk
Loosen the nut and use the 6 mm hex wrench to loosen the set screw (1, Fig. 7) by
at least one turn. Then, rotate the spoke handles to the left (2) to disengage the
mandrel from the machine (3).
Use the 5 mm hex wrench (1, Fig. 8) and remove the spindle disk (2). Then, install
the new disk (3) onto the pin 4 and tighten with the same screws.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
3
1
Fig. 7. Removing the mandrel from the machine
4
2
3
1
Fig. 8. Replacing the spindle disk
This document is protected by copyrights.
16
PRO 5 PB/PBE/PBC
2
Advertisement
Table of Contents
