Control; Operation; The Clock; Setting The Clock - Aiwa CX-ZR525 Operating Instructions Manual

To use the FUNCTION button on the remote control
The FUNCTION buttcm substitutes for the function buttons
(TAPE, TUNER/BAND, PHONO, VIDEO/AUX, CD) on the main
unit
Each time the FUNCTION button is pressed, the next function is
selected cyclically.
SETTING THE CLOCK
f'.. - ----.}
mma
K ---4=3!
Wr2LEAR
1,3,5
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
1
C3C9
am
'aoa
SHIFT
~acn=
'6"- '-"
}.. --- -.,/'
f
\,,
,,.J
2,4
BEFORE OPERATION
Set the time as follows while the power is off.
Press the 11 SET
button.
The hour flashes.
1
2
3
4
5
POWER
(
Press the 1+ DOVI/N or ~ UP button
designate the hour.
Press the II SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the 14< DOWN or P4 UP button
designate the minute.
to
to m
To
turn the unit on
Press the POWER button.
l-he disc compartment may open and close to reset the unit.
Press the 1I SET button to set the minute and
complete setting.
The minute stops flashing cm the display and the clock starts
from 00 second.
DEMO (Demonstration) mode
After connecting the AC cord, the display window demonstrates
the functions of the unit. When the power is turned on, the DEMO
display is overridden by the operation display. When the power
is turned off, the DEMO mode is restored.
To
correct the current time
Press the POWER button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To cancel DEMO mode
Press the DEMO button. To re-activate, press again.
To
display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control, The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
Flash
window
The window on the top of the unit lights up or flashes while the
unit is being powered on.
l-o turn off the light, press the CLEAR button on the main unit
while pressing the CD button. To turn back on, repeat the above.
This operation does not function during recording.
To
switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the CLEAR button within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
After use
Press the POWER button to turn off the power. The display
changes to clock.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
ENGLISH
6