Specifications - Sony CMT-MD1DX Operating Instructions Manual

Troubleshooting (continued)
Smart Space
The signal was input again after silence
continued for 30 seconds or less during
digital recording.
TOC Reading
The system is reading the TOC information
of the MD.
TOC Writing
The system is writing the information of
recorded or edited contents.
Track End
You have reached the end of the MD while
adjusting the division point during Divide
Function.
TUNER
Name Full
The system has stored the maximum
number of characters to be input.
CD
Name Full
There is no more space to store track or
disc titles.
– OVER –
You have reached the end of the CD while
pressing CD + during pause.
58

Specifications

Amplifier section
AUDIO POWER SPECIFICATIONS:
(USA models only)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 4 ohm loads both channels driven, from
90-15,000 Hz; rates 15 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from
250 milliwatts to rated output.
Canadian model:
Continuous RMS power output
European model:
DIN power output
Continuous RMS power output (Reference)
Music power output
Other models:
Continuous RMS power output (Reference)
Peak music power output 280 watts
Inputs
Outputs
PHONES (Stereo minijack):
SPEAKER:
17 + 17 watts
(4 ohms at 1 kHz, 10%
THD, 120 V) (Reference)
(Rated)
15 + 15 watts
(4 ohms at 1 kHz, DIN,
230 V)
17 + 17 watts
(4 ohms at 1 kHz,
10% THD, 230 V)
(Reference)
22 + 22 watts
15 + 15 watts
(4 ohms at 1 kHz,
10% THD, 240 V)
TAPE IN (phono jacks):
voltage 250 mV/125 mV,
impedance 47 kilohms
TAPE OUT (phono jacks):
voltage 250 mV
impedance 1 kilohms
accepts headphones of 8
ohms or more.
accepts impedance of 4 to
16 ohms.