Sony CMT-MD1DX Operating Instructions Manual page 57

Tuner
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.)
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
•Make sure the antenna is connected
properly.
•You cannot fold or roll up the antenna.
•The two wires comprising the FM
antenna have been pulled further apart
since the system was first purchased.
Repair or replace with a new one.
•The AM antenna wire is detached from
the stand.
A stereo FM program is not received in
stereo.
•Press STEREO/MONO so "STEREO"
appears.
If other problems not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Hold down 1/u, then plug the power cord
into the wall outlet again.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
Messages
One of the following messages may appear or
flash in the display window during
operation.
MD
Auto cut
The MD is pausing the recording because
silence continued for 30 seconds or more
during digital recording.
Blank Disc
The inserted recordable MD is new or all
tracks on the MD have been erased.
Cannot Copy
You cannot make a digital recording (see
"Guide to the Serial Copy Management
System" on page 54).
Cannot EDIT
You tried to edit in Program or Shuffle Play
mode.
Cannot REC
A pre-recorded MD is in the deck.
Disc Error
The inserted MD is damaged or does not
contain a TOC.
Impossible
You tried to combine from the first track on
an MD, which is not possible. You tried to
divide the first or end of the track.
Level Over
A strong signal was input during analog
recording in the TAPE function. Reduce the
recording level following the procedure
(see "Troubleshooting" on page 56).
MD Disc Full
There is no time remaining on the disc (see
"System limitations of MDs" on page 54).
MD NO DISC
There is no MD in the deck.
MD Protected
The inserted MD is protected against
erasure.
Name Full
There is no more space to store track or
disc titles.
New
The MD stands by for recording on a brand
new MD or from the last recorded portion.
No Name
The inserted MD has a track numbers but
no disc titles.
No Track
The inserted MD has a disc title but no
tracks.
MD End
You have reached the end of the last track
during high-speed search.
Push STOP !
You pressed PLAY MODE during play.
continued
57