Sony CMT-MD1DX Operating Instructions Manual page 52

Timer recording radio programs
(continued)
5
Set the time to start recording.
Press +/– to set the hour, then press
ENTER/YES.
The minute indication flashes.
O N
Press +/– to set the minute, then press
ENTER/YES.
The hour indication flashes again.
6
Set the time to stop recording
following the procedure in step 5.
7
Press ENTER/YES.
The start time, followed by the stop time,
preset number and the "MD" appear,
then the original display appears.
8
Insert a recordable MD.
9
Press 1/u to turn off the system.
52
REC
LEVEL SYNC -
DBFB
8 0 : 0
To change the setting
Start over from step 1.
To check the setting / To reactivate
the timer
Press CLOCK/TIMER SELECT repeatedly
until "REC TIMER" appears. The start time,
followed by the stop time, the preset number,
and the "MD" appear, then the original
display appears.
To cancel the timer
Press CLOCK/TIMER SELECT repeatedly
until "TIMER OFF" appears.
Tip
When you record from the radio, you can mark on
the MD, the start time, the stop time and the title
automatically if you have labeled the preset stations
(see page 47).
Notes
• You cannot activate wake up timer and recording
timer at the same time.
• Do not operate the system from the time the
power turns on until the recording starts (about 20
seconds).
• When you record on a blank MD, the first 15
seconds are not recorded.
• If the power is on about 20 seconds before the
preset time, the recording will not be made.
• The volume is reduced to minimum during
recording.