Sony CMT-MD1DX Operating Instructions Manual page 10

Step 3: Presetting radio stations
(continued)
5
Press ENTER/YES on the remote.
6
Press +/– on the remote to select the
preset number you want.
F M
7
Press ENTER/YES on the remote.
The station is stored.
8
Repeat steps 1 through 7 to preset
other stations.
To tune in a station manually
Press TUNING MODE on the remote
repeatedly until "MANUAL" appears in step
2, then press TUNING +/– to tune in the
station and continue from step 4.
To change the preset number
Start again from step 1.
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the
AM tuning interval, tune in any AM station
first, then turn off the power. While holding
down the FUNCTION button, turn the power
back on. When you change the interval, all
the AM preset stations are erased. To reset
the interval, repeat the same procedure.
10
LEVEL SYNC -
TUNED
8 7 5 H . M z
The preset number
Tips
• The preset stations are retained for a day even if
you disconnect the power cord or if a power
failure occurs.
• You can create titles for the preset stations (see
page 47).
• To improve broadcast reception, reorient the
supplied antennas or connect the optional external
antenna.
• When an FM program has static noise, press
STEREO/MONO on the remote until "MONO"
DBFB
appears. There will be no stereo effect, but the
reception will improve. Press the button again to
1
restore the stereo effect.