Md - Editing; Before You Start Editing; Labeling An Md; Name Function - Sony CMT-C7NT Operating Instructions Manual

MD — Editing

Before you start editing

Before editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
Check the following, before editing.
1
Check the tab of the MD to be edited.
If the MD is record protected, "C11" and
"Protected" appear alternately and the MD
cannot be edited.
Slide the tab to close the slot.
2
Press PLAY MODE on the remote in
stop mode repeatedly until both
"PROGRAM" and "SHUF" disappear.
You can edit the MD only in normal play
mode. You cannot edit the MD in Shuffle or
Program Play.
To cancel the last edit (page 39)
Use Undo Function to cancel the last edit and
restore the contents of the MD to the condition
before the edit.
To quit while editing
Press MENU/NO on the remote.
After editing
Press MD Z to remove the MD or press ?/1
(power) to turn off the system.
"TOC" starts flashing. The TOC is updated and
editing is completed.
Before pulling out the power cord
MD editing is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
power cord before updating the TOC (while
"TOC" is lit) or while updating the TOC (while
"TOC" is flashing) to ensure a complete
editing.

Labeling an MD

— Name Function

You can create titles for your recorded MDs
and tracks as follows.
During recording
If "TEXT" lights up or flashes during
recording, you can record the CD TEXT
information onto the MD as follows:
• Automatically during recording
When "TEXT" is lit, the CD TEXT
information is automatically recorded.
• Manually during recording
When "TEXT" flashes, press NAME EDIT/
SELECT on the remote, and then press
ENTER/YES on the remote to record the
title of the current track.
Note
Depending on the disc, the CD TEXT information
may not be recorded automatically.
continued
29