Mitsubishi Electric A800 Plus Instruction Manual page 95

Check and clear of the fault history
Clearing the fault history
POINT POINT
• Set Err.CL Fault history clear = "1" to clear the fault history.
Turning ON the power of the inverter
1.
The monitor display appears.
Selecting the parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn until
Fault history clear
Turn to change the set value to "
" " and "
4.
94
PROTECTIVE FUNCTIONS
Operation
(fault history clear) appears. Press
". Press
" are displayed alternately after the fault history is cleared.
•Turn to read another parameter.
•Press to show the setting again.
•Press twice to show the next parameter.
to read the present set value. "
to start clear.
" (initial value) appears.