Troubleshooting; Specifications - Sony CDP-CX350 Operating Instructions Manual

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
The CD does not play.
/There is no CD in a slot ("–NO DISC–"
appears).
Insert a CD.
/Insert the CD with the label side facing right.
/Clean the CD (see page 40).
/Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 40).
The remote does not function.
/Remove obstacles in the path of the remote and
the player.
/Point the remote at the remote sensor
the player.
/Be sure to set up the remote correctly.
/Replace all the batteries in the remote with new
ones if i appears in the remote's display.
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.

Specifications

Compact disc player
Laser
Laser output
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Outputs
Jack
type
Phono
LINE OUT
jacks
on Optical
DIGITAL OUT
output
(OPTICAL)
connector
General
Power requirements
Where purchased
Canada
Europe
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Additional Information
Semiconductor laser ( = 780 nm)
Emission duration: continuous
Max 44.6 W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
20 Hz to 20 kHz ±0.5 dB
More than 108 dB
More than 93 dB
Less than 0.0045 %
More than 100 dB
Maximum Load impedance
output
level
2 V Over 10 kilohms
(at 50 kilohms)
–18 dBm Wave length: 660 nm
Power requirements
120 V AC, 60 Hz
220 –230 V AC, 50/60 Hz
13 W
430 189 484 mm (17 7 1/2 19 1/8 in.)
incl. projecting parts
8.5 kg (18 lbs 12 oz)
41 GB