Colorlight Z6 Super Controller User Manual page 10

③ Clipping
Select signal source of the image that needs to be clipped in Input Signal Area, click [Set] to
enter the clipping interface.
In the clipping interface, check [Clipping], set X, Y, width and height, then click [Save] to
complete.
④ Splicing
Select DVI signal source in Input Signal Area, click [Set] to enter the splicing interface; there is
only one specific splicing mode, set width and height of splicing unit of it, then click [Save] to
complete. Note: Splicing is only available for DVI signal source.
8