How Do I Change Between Fahrenheit And Celsius; Why Are My Wind Cups Not Spinning; Can I Replace My Wind Cups; Wind Reading 0.00: Why Do I Only See 0.00 For Wind Speed - La Crosse Technology V21-WTH General Information Manual

HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?

• On your sensor, open the battery cover and press the F/C button. This will change the
temperature display on the sensor only.
• On your station enter the
on the station.
• Check for debris or ice preventing cups from moving.
• Check mounting location. Look for obstructions that prevent the wind from reaching the
sensor.
• In most cases, the wind sensor needs to be 4-6ft above the highest point on the roof in
order to clear nearby obstructions and read accurately.
• A 50-foot clearance in all directions is best.
• Push down firmly on the center of the cups to reseat them.
• Cups are replaceable.
Occasionally, a bad storm with hail or debris that will damage your wind cups. These are easily
replaced.
Replace wind cups:
1. Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit on the flat side of the metal stem on the sensor.

WIND READING 0.00: WHY DO I ONLY SEE 0.00 FOR WIND SPEED?

The 0.00 means your wind sensor is connected to your station.
• Check that the cups spin freely. Something may be preventing movement.
• Are your wind cups unbroken? After a storm it is good to check this.

WIND DASHES: WHY ARE THERE DASHES FOR WIND READINGS?

Dashes indicate the connection is lost between your station and the wind sensor.
• My first thought is always to check that my
now is not, low batteries are the most common connection problem.
• Next, check your distance, resistance and
at the same location, this is likely not the issue. However sometimes there is new growth on
trees or bushes that cause another barrier. Radio Frequency (RF) signal does not travel well
through foliage due to the moisture content.
program menu to select Fahrenheit or Celsius temperature display

WHY ARE MY WIND CUPS NOT SPINNING?

CAN I REPLACE MY WIND CUPS?

batteries are good. If it has been working and
interference. If everything was working previously
16 | P a g e