Table of Contents
Advertisement
Note:
Dekolink recommends to set limit (-3dB) from the output power selected.
2. Choose the External Alarm option to be enabled when normally Open or Close
status according to your application.
3. Press the Door Alarm Switch to switch the led from red to green.
4. After setting the repeater parameters, click the Send Parameters button.
Note:
Now the repeater is loaded with the new configuration.
6.5. System Activation
1. Connect Donor and Service antennas with RF coaxial jumper to Repeater's
"Base Port" and "Mobile Port" respectively.
2. Enable downlink and uplink amplifiers by clicking "PAmp" checkbox.
3. Click the Send Parameters button.
4. Check the status of the leds in the repeater alarm tab (all leds should be colored
green except the "Door open").
5. Switch to Parameters and Control tab and check if all the parameters are as
desired.
6. Test the performance of the system in the coverage area (drive test)
7. Disconnect the data cable from the repeater and close the door with the supplied
key.
Note:
The repeater is up and running....
Dekolink™—IDEN Repeater Hardware Manual
S
I
YSTEM
NSTALLATION
23
Advertisement
Table of Contents
