Table of Contents
Advertisement
6.3.1. Repeater Installation
Mark the four drilling holes on the surface of the wall based on the mounting
holes on the repeater chassis.
Align the housing so that the mounting brackets fit into the holes in the wall.
Use tire bolts, hex-head bolts, and M8 washers screw the housing in firmly.
Note:
These bolts and washers are NOT supplied with the repeater. Leave
enough room so that personnel can access the repeater even when its
door is open.
6.3.2. Base/Donor Antenna Installation
Choose an antenna with high side lobe attenuation that allows the maximum
isolation from the service/ mobile antenna.
Point the antenna in the direction of the base station to receive maximum input
power.
Make sure the antenna is in line of sight with the base site. You can raise the
antenna higher if necessary.
Measure all the necessary specifications of the antenna.
6.3.3. Mobile/Service Antenna Installation
Note:
Before installing the Mobile/Service antenna, see the FCC regulations for
information regarding recommended distances between the antennas
and population centers.
Choose an antenna that allows the maximum isolation from the Base/Donor
Antenna.
Point the antenna in the direction of the service area you want to cover.
Measure all the necessary specifications of the antenna.
Dekolink™—IDEN Repeater Hardware Manual
S
I
YSTEM
NSTALLATION
15
Advertisement
Table of Contents
