Table of Contents
Advertisement
Authorized Customer Use
Antenna Isolation
Note:
recommends that the isolation between the Base/Donor and
Mobile/Service antennas will be at least 12 dB higher than the Repeater
set gain.
Note:
Insure proper vertical or horizontal distance separation between Donor
and Service antennas
AT THIS STAGE DO NOT CONNECT THE ANTENNAS TO
Note:
THE REPEATER. THEY WILL BE CONNECTED WITH RF
COAXIAL JUMPERS AT THE ACTIVATION STEP.
6.3.4. AC Power Connection
Plug in AC power cable to the repeater (the repeater automatically turns
on) . The green led at repeater front panel turns on as an indication of
power on (there is no On/Off switch).
6.3.5. PC/Laptop Connection
Connect the laptop to the repeater controller (CB 04) using the supplied RS232
Cable to P3-RS232 on the controller (Fig 4). The controller is located inside the
repeater box. Open the repeater door and identify the controller. Make sure that the
status led on the controller is blinking before you connect the cable.
Connect laptop serial port COM1 to the other side of the cable
RS232 Cable
16
. For proper Repeater operation, Dekolink
Status Led
Figure 4: Connection of the Repeater to the Laptop
Release 1.00
Advertisement
Table of Contents
