Notes And Cautions - Samsung POWERbot SR20J925 Series User Manual

notes and cautions

Charging
Note
f If the battery overheats during charging, it
may take longer to charge.
f When automatic charging is not working,
please check the followings.
– Turn the emergency switch (on the bottom of
POWERbot) off and on again.
– Unplug the charger's power plug and then plug
it back on.
– Check whether there is any foreign matter in
the charge pins and clean POWERbot and the
charge pins of the charger with a dry cloth or
rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the charger.
f If POWERbot is left detached from the
charger, the battery will drain naturally.
– Try to keep POWERbot being charged on the
charger. (Turn off the emergency switch and
leave the charger unplugged when planning
to leave the house for long periods of time by
going on a business trip or vacation, etc., )
in use
Note
f The POWERbot may get caught on
thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move POWERbot to an area where it
can move easily and then turn on the power
again.
f The POWERbot cannot completely clean
areas it cannot enter, such as corners,
between the wall and sofa, etc.
– Please use another cleaning tool to clean them
regularly.
f The POWERbot cannot vacuum clumps of
dirt, so some may remain on the floor after
cleaning.
– Please use another cleaning tool to clean them
regularly.
f If the battery becomes low during Auto clean
mode, POWERbot will recharge and finish
cleaning the remaining area after recharging.
(Repeat cleaning frequency: 1 time)
f You cannot select and execute Manual clean
mode while charging.
– If you press Manual clean / Point cleaning
button while charging, the POWERbot will be
detached from the charger and then turn into
the standby mode.
f Do not unnecessarily move POWERbot or
press buttons while it is in Auto clean mode. It
assumes that cleaning is complete and starts
cleaning again from the beginning.
Cleaning and maintenance
Note
f If you washed the dustbin and filter with water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in a shade before use.
caution
f Watch your finger when attaching or
detaching the filter, since they may get stuck
in the dustbin's intake.
f To avoid blockages by foreign matter, do not
let toothpicks, cotton swabs etc. from being
vacuumed by POWERbot.
f If it is difficult to remove foreign matters from
the Power brush, contact a service center.
f Since the power brush removes dirt from the
floor during cleaning, foreign matters such as
thread, long hair, etc. may get caught in it.
Therefore check and clean it regularly.
ENGLISH-28