iControl Technicolor TCA200 User Manual page 76

TouchScreen User Guide
The TouchScreen locates the repeater and updates the repeater's firmware, if necessary. The
repeater is also configured to use the same communication channel and have the same SSID as
the security router.
Note:
3. When the configuration is complete, tap Next. The repeater has been added successfully.
Immediately disconnect the repeater from the security router and power off the repeater. Then
determine where the repeater will be placed and power on the repeater.
To delete a security Wi-Fi Repeater
When a repeater is deleted, any connected devices can communicate with the security router directly, if
they are within range.
1. To delete the repeater from the security system, tap Home Devices > Wifi Repeater > Delete a
Wifi Repeater.
The Delete Wi-Fi Repeater screen is displayed.
2. Tap Next. The TouchScreen deletes the repeater from the security system. To add this router back
to the security system, you must reset factory settings as directed by the repeater's doc-
umentation.
76
If the system cannot find the repeater, reset the repeater to its factory settings, then
restart it. Tap Back, then try again when the status indicator on the repeater is green.