Cisco Firepower 1600 Hardware Installation Manual page 41

Maintenance and Upgrade
Warning
Statement 1074—Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Step 1 Remove the drive that you are replacing:
a) Press the release button on the face of the drive tray.
b) Grasp and open the ejector lever and then pull the drive tray out of the slot.
Figure 34: Remove the Drive
1
Step 2 Remove the four drive-tray screws that secure the drive to the tray and then lift the drive out of the tray.
Ejector handle
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2 Release button
Remove and Replace a Drive
37