Cisco Firepower 1600 Hardware Installation Manual page 40

Remove and Replace a Drive
• Emergency shutdown—Press and hold the Power button for four seconds to force the main power off and immediately
enter standby mode.
Remove and Replace a Drive
Note
The drives are hot-swappable. You do not have to shut down the FMC to remove or replace drives.
Note You cannot add more drives to your FMC. You can only replace the drives in the slots that are supported for
your model.
Before you begin
Warning Statement 1018—Supply Circuit
To reduce risk of electric shock and fire, take care when connecting units to the supply circuit so that wiring
is not overloaded.
Warning
Statement 1019—Main Disconnecting Device
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device.
Warning Statement 1024—Ground Conductor
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available.
Warning
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073—No User-Serviceable Parts
No serviceable parts inside. To avoid risk of electric shock, do not open.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
36
Maintenance and Upgrade