Kolpin 26400 User Manual page 4

3. The Aluminum Extrusion will need to be cut down to custom fit your machine. Mark on the
extrusion where it needs to be cut by placing it tight on one End Cap and marking where the other
End Cap meets on the extrusion. And as always check you measurements twice. Cut the
Aluminum Extrusion with a hack saw.
4. After cutting, remove the Right Hand Extrusion End Cap form the Roll Bar. Place the Right Hand
Extrusion End Cap into the Aluminum Extrusion and mount back onto the roll bar, using the 4 – ¼"
x 2.25" (or 5.50") Truss Head Bolts and 4 – ¼" Nylock Nuts. Position the mount so it is high enough
to tilt the dump bed. Tighten securely.
brackets. Very little torque is needed to hold the system securely.
4. The 26500 Bracket ( also sold separately) is compatible with the following Kolpin Products:
A. Gun Boot 5.0 (20090-95)
B. Boottector Bracket (20035)
C. Fuel Pack Bracket (89475)
D. UTV/ATV Basket (53200)
E.
Rev. 03
Note: Over tightening can cause damage to the system or
E. Gear Grips (20085)
F. Gun Grips II (20072)
G. Universal Loop Bracket (20032)
H. Double Gun Boot Mount (26510)
F.
C.
A&B.