Hydraulic System Instruction - Blastrac BMS-220 ADB Operating Manual

Hydraulic system instruction

To check oil level on the side of tank is installed indicator. Level should be half the glass of the level indicator.
If you don't see the oil in the indicator, the level is too low. If the level is above the glass, the level is too high.
Next to the it is mounted plug which close the hole by which oil can be refill.
For refill the oil you need HV46 hydraulic oil. (Part number E00481 – Hydraulic oil)
1) Oil level indicator
2) Plug to refill oil in tank
At least one time during year oil from system and filter should be replace. For this operation charger need to
be disconnected from power. To remove oil drain plug need to be removed. It is located at the bottom of tank
on backside.
18