11 SERVICE WORK ON THE CHASSIS
11.8
98
Adjusting the steering head bearing play
R05381-10
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
»
If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and adjust if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws
. Loosen screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
(
p. 98)
p. 92)
p. 92)
2
.
3
.
M20x1.5
12 Nm (8.9 lbf ft)