KTM 690 Enduro R 2019 Owner's Manual page 236

20 TROUBLESHOOTING
Faults
Engine overheats.
Malfunction indicator lamp
lights up
Engine dies during the journey
ABS warning lamp lights up
High oil consumption
Headlight and parking light are
not functioning
Turn signal, brake light and
horn not functioning
234
Possible cause
Air in cooling system
Error in the electronic fuel
injection
Lack of fuel
Fuse 1, 2 or 3 blown
The ABS fuse is blown
Large difference in wheel
speeds of the front and rear
wheels
Malfunction in ABS
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscos-
ity)
Fuse 6 blown
Fuse 5 blown
Action
–
Fill/bleed the cooling system.
( p. 205)
–
Read out the fault memory using the
KTM diagnostics tool.
–
Refuel. ( p. 77)
–
Change the fuses of individual power
consumers. ( p. 183)
–
Change the ABS fuses. (
–
Stop the vehicle, switch off the igni-
tion, and start it again.
–
Read out the ABS fault memory using
the KTM diagnostics tool.
–
Route the vent hose without bends or
change it if necessary.
–
Check the engine oil level. (
–
Change the engine oil and oil filter,
clean the oil screens. (
–
Change the fuses of individual power
consumers. ( p. 183)
–
Change the fuses of individual power
consumers. ( p. 183)
p. 181)
p. 215)
p. 216)