Table of Contents
Advertisement
1.
Do Not bring any heat or flame source near battery.
DO NOT PUSH ON CENTER
TO POSITION BATTERY
2.
Do Not use any lubricant other than EnerSys Pro-Slide or Dow Corning Silicon
Compound #111 to lubricate rails to facilitate sliding of batteries.
3.
Do Not lift any cells by the terminal posts.
4.
Do Not tamper with seal nuts on the cell post.
Do Not remove coating from post or connectors and expose any bare copper.
5.
6.
Do Not allow cell temperature to exceed 110
7.
Do Not clean cell with anything other than water/bicarbonate of soda.
8.
Do Not over torque connections.
9.
Do Not store EnerSys Lead Antimony batteries for over three months without charge –
EnerSys Lead Calcium for over six months without charge, at normal temperatures.
*
These are only a few of the precautions. Please read this manual thoroughly for complete details.
www.enersys.com
PRECAUTIONS*
EnerSys
EnerSys EMEA
P.O. Box 14145
Brussels, Belgium
Reading, PA 19612-4145
Tel: +32 (0)2 247 94 47
USA
EnerSys Asia
Tel: +1-610-208-1991
Guangdong, China
+1-800-538-3627
Tel: +86 755 2689 3639
USE EDGE OF MODULE
WHEN POSITIONING BATTERY
o
F during charging.
Represented by:
Trademarks and logos are the property
Printed in U.S.A
© 2007 EnerSys. All rights reserved.
of EnerSys and its affiliates unless
otherwise noted.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PowerSafe Data Safe and is the answer not in the manual?
Questions and answers