Installation And Commissioning; Required Tools - Siemens TALON Series Technical Reference Manual

TX-I/O Island Bus

Installation and Commissioning

Required Tools

40
Siemens Industry, Inc.
588-587
NOTE:
For Smoke Control applications, the field panel controller must be installed in the
lower half of the enclosure.
The TX-I/O island bus is automatically created by connecting the TX-I/O devices one-
after-another on a DIN rail.
Basic Steps for Connecting Devices to the DIN Rail
1. Slide out the mounting tabs.
2. Align the channel on the back of the device with the DIN rail.
3. Using a flat blade screwdriver, push in each mounting tab until it clips onto the DIN
rail.
1. Align the I/O module with the Power Supply or Bus Connection Module and slide
the I/O module down over the DIN rail and TX-I/O bus connector.
2. Push in each mounting tab until it clips onto the DIN rail.
2
1
3
5
Connecting Devices to the TX-I/O Island Bus.
Screwdrivers for I/O Modules
The I/O module connection terminals have slotted screws.
No. 1 screwdriver

Shaft diameter maximum 0.18" (4.5 mm)

Minimum shaft length 1" (26 mm); however, 1.6" (40 mm) allows access to the

screws while plug-in module is in the "parked" position.
CONFIDENTIAL: For internal use only
4
TALON TX-I/O Modules and Island Bus Technical Reference
4/6/2010