Honda CBR 250R Manual page 58

Use only the Honda Genuine oil filter or
a filter of equivalent quality specified for
your model. Using wrong filter or a non-
Honda filter which is not of equivalent
quality may cause engine damage.
NOTICE
Improper installation of the oil filter can
cause serious engine damage.
6. Install the oil filter spring into the oil
filter cover. Then, install the new gasket
and oil filter cover.
Make sure the oil filter cover bolts are
tightened securely to the specified
torque.
Oil filter cover bolts torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
7. Check that the sealing washer on the
drain bolt is in good condition and install
the bolt. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Engine oil drain bolt torque:
24 N·m (2.4 kgf·m , 18 lbf·ft)
52
CBR 250R
8. Fill the crankcase with the recommended
grade oil; approximately:
1.4 L (1.5 US qt , 1.2 Imp qt)
without oil filter
1.5 L (1.6 US qt , 1.3 Imp qt)
with oil filter
9. Install the oil filler cap.
10. Start the engine and let it idle for 3 - 5
minutes.
11. 2 - 3 minutes after stopping the engine,
check that the oil level is at the upper
level mark in the inspection window
with the vehicle
level ground. Make sure there are no oil
leaks.
Honda Motorcycle & Scooter India Pvt. Ltd.
upright on firm,