Sending A Text Message - Motorola MTM800 Feature User Manual

Sending a Text Message

This feature allows you to send new messages, send
messages based on user defined templates or send
messages based on predefined templates.
The predefined templates are programmed into your
MTM800 by your Service Provider. The user defined
templates are Inbox messages or, new Outbox messages
that you choose to store in your MTM800 memory. User
defined messages may also be programmed into your
MTM800.
You are allowed to edit your messages before sending them.
You can send a message when the terminal is idle or during a
Group/Emergency/Broadcast Call (if configured).
If configured, a message will alert you of an incoming Group/
Emergency/Broadcast call, of your joining it, or of its end.
Receiving a Group/Emergency/Broadcast Call before or
during text message editing
You can be in a call and start message editing while listening
to the call.
Or you can start message editing, receive a call and listen to
the call while editing the message.
To join a call received during message editing, press PTT.
Sending a text message during a Group Call
(if configured)
Press PTT. One of the following might occur:
• The call started before message editing began. The
terminal will leave the call and send the message. If the
call is still active, the terminal will re-join it.
• The call started after message editing began. The terminal
will leave the call and send the message. The terminal will
return to edit mode.
• The call started before or after message editing began.
The terminal will send the message while staying in the
48
( 1 3)