Pre-Maintenance Procedures; Lifting The Machine; Lubrication; Greasing The Machine - Toro Sand Pro 2040Z Operator's Manual
Traction unit, serial no. 403300001 and up
Hide thumbs
Also See for Sand Pro 2040Z:
- Service manual (130 pages) ,
- Operator's manual (60 pages) ,
- Operator's manual (16 pages)
Table of Contents
Advertisement
Pre-Maintenance
Procedures
Lifting the Machine
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the
machine.
Refer to
Figure 33
for the support points.
Figure 33
1. Support points (rear)
g023550
2. Support points (front)
Lubrication
Greasing the Machine
Service Interval: Every 100 hours
Grease Type: No. 2 lithium grease
Grease each grease fitting located on the front wheel
hub, the belt tensioner, and the attachment lift as
follows:
1.
Park the machine on a level surface, lower the
attachment, move the control handles to the
neutral-locked position, engage the parking
brake, shut off the engine, and remove the key.
2.
Wipe the grease fitting clean so that foreign
matter cannot be forced into the bearing or
bushing.
3.
Attach a grease gun to the fitting, and pump
grease into the fitting.
4.
Wipe up any excess grease.
•
Front wheel bearing
•
Belt tensioner
(1)—Figure 35
32
(1)—Figure 34
Figure 34
g023436
Advertisement
Table of Contents
