Filling The Fuel Tank; Checking The Level Of The Hydraulic Fluid - Toro Sand Pro 2040Z Operator's Manual

Filling the Fuel Tank

Fuel tank capacity: 17 L (4.5 US gallons)
Recommended Fuel:
•
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 87 or higher ((R+M)/2 rating method).
•
Ethanol: Gasoline with up to 10% ethanol
(gasohol) or 15% MTBE (methyl tertiary butyl
ether) by volume is acceptable. Ethanol and MTBE
are not the same. Gasoline with 15% ethanol
(E15) by volume is not approved for use. Never
use gasoline that contains more than 10% ethanol
by volume, such as E15 (contains 15% ethanol),
E20 (contains 20% ethanol), or E85 (contains 85%
ethanol). Using unapproved gasoline may cause
performance problems and/or engine damage
which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel
containers over the winter unless a fuel stabilizer
is used.
•
Do not add oil to gasoline.
1. Park the machine on a level surface, lower the
attachment, move the control handles to the
neutral-locked position, engage the parking
brake, shut off the engine, and remove the key.
2. Clean the area around the fuel-tank cap
16).
Figure 16
1. Fuel-tank cap
3. Remove the fuel-tank cap.
4. Fill the tank to about 25 mm (1 inch) below the
top of the tank (bottom of the filler neck). Do not
overfill.
5. Install the cap.
6. Wipe up any fuel that may have spilled, to
prevent a fire hazard.
Checking the Level of the
Hydraulic Fluid
Service Interval: Before each use or daily—Check
Important:
hydraulic fluid only when the engine and the
hydraulic system are cold.
The reservoirs of the machine are filled at the factory
with high-quality hydraulic fluid. The best time to
check the hydraulic fluid is when the fluid is cold. The
machine should be in the transport configuration. If
the fluid level is below the top of the horizontal part of
the cut-out sight window on the rear of the hydraulic
reservoirs (Figure
the acceptable level. Do not overfill the reservoirs.
If the fluid level is at the top of the horizontal part of
the sight window, no fluid addition is required. The
recommended replacement fluid is:
Fluid Type: Toro Premium Transmission/Hydraulic
Tractor Fluid or Mobilfluid
Capacity:
•
Left side—1.9 L (2.0 US qt)
•
Right side—2.0 L (2.1 US qt)
Alternative fluids: If the specified fluid is not available,
other universal tractor hydraulic fluids (UTHF) may
(Figure
be used, but they must be only conventional,
petroleum-based products, not synthetics or
biodegradable fluids. The specifications must fall
within the listed range for all of the following material
properties and the fluid should meet listed industry
standards. Check with your fluid supplier to see if the
fluid meets these specifications.
Note:
Toro will not assume responsibility for damage
caused by improper substitutions, so use only
products from reputable manufacturers who will stand
behind their recommendation.
g023449
19
the level of the hydraulic fluid.
For accuracy, check the level of the
17), add fluid to bring the fluid to
® 424